Allied Telesis AT-UWC Series - Manual (Page 29)

Chapter 1: Getting Started
29
Saving the Changes
When you change settings of the AT-UWC WLAN Controller and click the
Submit button on each page, the changes are stored in the running
configuration. The settings in the running configuration are deleted when
the AT-UWC WLAN Controller reboots. You must save the changes to the
startup configuration if you want to keep the changes after the AT-UWC
WLAN Controller reboots.
To save the changes to the startup configuration, do the following:
1. Start a management session. See “Starting a Management Session”
on page 16.
The Allied Telesis Unified Wireless Controller starts as shown in
Figure 17.
Figure 17. AT-UWC WLAN Controller Screen
2. From the Navigation panel on the left, go to System > Save All
Applied Changes.
The Save All Applied Changes screen is displayed as shown in Figure
18 on page 30.