Allied Telesis AT-CM70S - Manual (Page 100)

Appendix A: Technical Specifications
100
Stand-Alone – Converteon™ Module Configured for MissingLink™
Test
Figure 49 on page 98 shows a stand-alone configuration for a
Converteon™ module (Module A) that has been configured for the
MissingLink™ Test mode. Refer to “MissingLink™” on page 44 for
configuring the module of the Missing Link™ Test mode. Module A is
connected to an AT-8524M (Switch 1) with a copper cable and to an
AT-8516F/SC (Switch 2) with a dual fiber cable.
Table 28 shows the Link (LK) LED status for each of the ports involved
when the cables are connected and disconnected from Module A's ports.
Table 28. Stand-Alone – Converteon™ Module in MissingLink™ Test Mode
Network
Device
Port
Link
Converteon™ Module Cable Status
All Cables
Connected
Copper Cable
Switch 1 to
Module A -
Disconnected
Module A
Transmit/
Receive
Fiber Cable
Disconnected
Port
LINK
Status
Switch 1 Copper
LK LED ON OFF OFF
Converteon™
Module A
Copper
LK LED ON OFF OFF
Fiber
LK LED ON OFF OFF
Switch 2 Fiber
LK LED ON OFF OFF