Allied Telesis AT-CM70S - Manual (Page 79)

Converteon Media Converter Line Cards Reference Guide
79
Resetting the AT-CM70S Line Card
To reset the CPU on the AT-CM70S line card, perform the following
procedure.
1. Locate the CPU RESET button which is recessed in the front panel of
the AT-CM70S line card.
Note
This CPU RESET button is used to reset the CPU on the AT-CM70S
line card only, and is not for other line cards and/or the module
installed in the expansion slot at the rear of the AT-CV5000 chassis.
You may need to reset the CPU on the AT-CM70S line card after
upgrading the firmware or after you have made a configuration
change that requires resetting the module to activate the change.
2. Press the reset button with the tip of a pen or a non-conductive pointy
object, as shown in Figure 36.
Figure 36. Resetting the CPU on the AT-CM70S Line Card
F
P
CPU RESET
C
O
N
S
O
L
E
L/A FD 100
2
AIS 1 2
4
3
LOTC NML
1
RCL NML
T
X
RDY
912