Allied Telesis AT-WL2411 - Manual (Page 101)

AT-WL2411 Version 1.80 Installation and User’s Guide
101
Configuring IP
Address List
If you enabled IGMP on the root access point, you will need to enter the
Class D IP multicast address in the IP address list.
To configure the IP address list, perform the following procedure:
1. From the Main Menu, select IP Tunnels then IP Addresses. The IP
Addresses screen as shown in Figure 34 is displayed.
Figure 34 IP Addresses Screen
2. If you enabled IGMP, enter the Class D IP multicast address. The
default is 224.0.1.65.
3. Enter the IP unicast addresses of the access points that can be the
endpoints of IP tunnels.
4. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see
Saving Your Configuration
Changes on page 46.