Allied Telesis AT-WL2411 - Manual (Page 54)

Configuring the Ethernet Network
54
Configuring the
Access Point as
a DHCP Client
You can use a DHCP server to automatically assign an IP Address to your
access point; that is, the access point can act as a DHCP client.
Note
You cannot configure the access point as both a DHCP server and a
DHCP client.
To configure the access point as a DHCP client, perform the following
procedure:
1. From the Main Menu, select TCP/IP Settings. The TCP/IP Settings
screen as shown in Figure 17 is displayed.
Figure 17 TCP/IP Settings Screen
2. Select the down arrow on the right side of the DHCP Mode field and
choose either Always Use DHCP or Enabled, if IP Address is Zero. If
you choose Enabled, if IP Address is Zero, make sure that the IP
Address field is 0.0.0.0.