Allied Telesis AT-WL2411 - Manual (Page 193)

AT-WL2411 Version 1.80 Installation and User’s Guide
193
Using Test Mode Commands
Within the access point monitor, test mode allows you to perform
certain test functions. Because the commands can cause undesirable
results if not properly executed, you should contact Allied Telesyn
Technical Support for assistance if you are unsure about the proper
procedure to use. Refer to
Contacting Allied Telesyn Technical Support
on page 15 for information.
TEST Purpose
Allows you to enter test mode where you can perform a variety of test
functions.
Syntax
TEST
To enter test mode, perform the following procedure:
1. Type Test and press <Enter>.
2. Enter a password. The default password is EV98203T (case sensitive).
When you are in test mode, the test prompt (test>) appears. Test mode
has a set of defined commands that you can use.