Configuring ip tunnel filters – Allied Telesis AT-WL2411 User Manual
Page 102
Configuring the Spanning Tree
102
Configuring IP Tunnel Filters
You can set both Ethernet and IP tunnel filters, and you can create
protocol filters for predefined protocol types. In addition, you can define
arbitrary frame filters based on frame content. For help configuring
Ethernet filters, see
To configure IP tunnel filters, perform the following procedure:
1. From the Main Menu, select IP Tunnels then Tunnel Filters. The
Tunnel Filters screen as shown in Figure 35 is displayed.
Figure 35 Tunnel Filters Screen
2. Check or uncheck the box on the right side of Allow IP Multicast to
Allow or Pass. This parameter specifies if the access point can receive
IP multicast packets through the IP tunnel port.
3. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see