Allied Telesis AT-WL2411 - Manual (Page 121)

AT-WL2411 Version 1.80 Installation and User’s Guide
121
To install a point-to-point or a point-to-multipoint bridge, perform the
following procedure:
1. Follow the instructions for installing a simple wireless network on
page 112 .
2. Configure the LAN ID. For help, refer to Configuring the Spanning
Tree Parameters on page 78.
3. Configure the station in the point-to-point bridge on the secondary
LAN by performing the procedure below:
a. From the Main Menu, select the link corresponding to the station
radio. The radio screen as shown in Figure 47 is displayed.
Figure 47 Radio Screen
b. Select the down arrow on the right side of the Node Type field
and choose Station then Submit Changes.
4. Configure the spanning tree settings for the point-to-point bridge
on the secondary LAN by performing the procedure below: