Allied Telesis AT-WL2411 User Manual
Page 32
Installation
32
8. To configure the access point or assign it an IP address for remote
configuration, attach one end of the RS-232 null-modem
management cable to the serial port on the unit and then attach the
other end of the cable to the serial port on your computer. For
instructions on how to further configure the access point, see
9. Power ON the unit by plugging one end of the power cord into the
power port on the access point and plug the other end into an AC
power outlet. The AT-WL2411 does not have an ON/OFF switch, so it
turned ON as soon as you apply power.
Caution
You must use the appropriate Allied Telesyn power supply with this
device or equipment damage may occur.
Your AT-WL2411 is now ready to begin transmitting data packets
between your end devices and your wired network.