Allied Telesis AT-WL2411 - Manual (Page 187)

AT-WL2411 Version 1.80 Installation and User’s Guide
187
Entering the
Access Point
Monitor
You can enter the access point monitor only through a connection on
the serial port and only during the boot process.
To enter the access point monitor, do the following:
❑ Press any key on the keyboard when you see this message
displayed during the boot process:
<Press any key within 5 seconds to enter the
access point monitor>
Note
Certain functions available through the access point monitor can
erase your configuration information. Allied Telesyn strongly
recommends that you only use the access point monitor when
absolutely necessary. For example, you might use the access point
monitor to upgrade your firmware or when instructed to do so by
qualified Allied Telesyn personnel.