Allied Telesis AT-S60 - Manual (Page 117)

AT-S60 Command Line User’s Guide
115
DELETE SWITCH MIRROR
Syntax
delete switch mirror=destinationport
port=sourceport
Parameters
mirror Specifies the destination port of the port mirror where
you want to remove source ports. This port must
already be functioning as a destination port of a port
mirror. (For information on how to specify ports, refer
to Specifying Ports on page 17.)
ports Specifies the source port to be removed from an
existing port mirror. You can specify more than one
port at a time.
Description
This command removes a source port, or ports, from a port mirror.
Note
To view the ports of a port mirror, see SHOW SWITCH MIRROR on
page 120.
Example
The following command removes Port 2 on the line card in Slot 12 from
the port mirror that is using Port 8 on the line card in Slot 2 as the
destination port:
delete switch mirror=2.8 port=12.2