Allied Telesis AT-S60 - Manual (Page 149)

AT-S60 Command Line User’s Guide
147
SHOW STP
Syntax
show stp [port=port]
Parameter
port Specifies the port whose STP parameters you want
to view. You can specify more than one port at a
time. (For information on how to enter ports, refer to
Specifying Ports on page 17.)
Description
This command displays the current values for the following STP
parameters:
❑ STP status
❑ Bridge identifier
❑ Bridge priority
❑ Hello time
❑ Forwarding delay
❑ Maximum age timer
You can also use this command to view the following STP parameter
settings for a switch port:
❑ Path cost
❑ Port priority
❑ Port STP state
Examples
The following command displays the switch’s STP settings:
show stp
The following command displays the STP settings for Ports 1 through 4
on the line card in Slot 5:
show stp port=5.1-4