Allied Telesis AT-S60 - Manual (Page 67)

AT-S60 Command Line User’s Guide
65
SET SNTP
Syntax
set sntp[dst=enabled|disabled]
[pollinterval=integer] [utcoffset=integer]
Parameters
dst Daylight savings time. By setting this parameter to
enabled, you allow the switch to automatically
adjust to daylight savings time. By setting this
parameter to disabled, you prevent the switch from
automatically adjusting to daylight savings time.
pollinterval The time interval between two successive queries to
the SNTP server. The range is 60 to 1200 seconds.
The default is 600 seconds.
utcoffset The time difference, in hours, between Universal
Coordinated Time (UTC) and local time. The range is
-12 to +12 hours. The default is 0 hours.
Description
This command enables or disables daylight savings time and sets the
polling and UTC offset times.
Example
The following command enables daylight savings time, sets the poll
interval to 300 seconds, and sets the UTC offset to -8 hours:
set sntp dst=enabled pollinterval=300 utcoffset=-8