Allied Telesis AT-S60 User Manual
Page 160
Chapter 14: RSTP Commands
158
migrationcheck
This parameter resets a RSTP port, allowing it to
send RSTP BPDUs. When an RSTP bridge receives
STP BPDUs on an RSTP port, the port transmits STP
BPDUs. The RSTP port continues to transmit STP
BPDUs indefinitely. Set the migrationcheck
parameter to yes to reset the RSTP port to transmit
RSTP BPDUs.
Note
Each time a RSTP port is reset by receiving STP BPDUs, set the
migrationcheck parameter to yes, allowing the port to send RSTP
BPDUs.
Description
This command sets a port’s RSTP settings.
Examples
The following command sets port cost to 1,000,000 and port priority to
224 (increment 14) on Port 4 on the line card in Slot 9:
set rstp port=9.4 portcost=1000000 portpriority=14
The following command changes Ports 6 to 8 on the line card in Slot 10
so they are not considered edge ports:
set rstp port=10.6-8 edgeport=no
The following command returns Port 7 on the line card in Slot 2 to the
default RSTP settings:
set rstp port=2.7 default