Allied Telesis AT-S60 - Manual (Page 92)

Chapter 6: Enhanced Stacking Commands
90
EXIT
Syntax
exit
Parameters
None.
Description
This command ends a management session. The menu or screen that is
displayed as a result of this command depends on whether your switch
is a master or slave as well as the configuration of the console mode on
your switch. If you configured your switch with the command line as the
console mode, entering the EXIT command ends the management
session. For a master switch, this command actually disconnects the
session. However, for a slave switch, entering the EXIT command ends
the slave session and displays the Stacking Services Menu on the master
switch.
If you left the console mode configured as menu, when you enter the
EXIT command, the AT-S60 Main Menu is displayed. For a master switch,
the AT-S60 Main Menu of the master switch is displayed. For a slave
switch, the AT-S60 Main Menu of the slave switch is displayed.
Note
To determine the master or slave status of your switch, use SHOW
SWITCH on page 55.
Example
The following command end a management session:
exit