Sony DCR-PC5 - Manual (Page 27)

27
Playback – Basics
— Playback – Basics —
Playing back a tape
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button. The
power lamp lights up.
(3) Press OPEN to open the LCD panel.
(4) Press
to rewind the tape.
(5) Press to start playback.
(6) Adjust the volume following the steps below.
1 Press FN to make PAGE1 appear (p. 16).
2 Press VOL. The screen to adjust volume appears.
3 Press –/+ to adjust the volume.
– : to make the volume down
+: to make the volume up
(7) Press OK to return to PAGE1.
5 4 2
6
1
3
VOL – +
OK
FN
POWER LOCK
VCR
MEMORY
CAMERA
OFF
the bar indicator
To return to FN
Press EXIT.
To stop playback
Press x.