Sony DCR-PC5 User Manual
Page 79
79
Editing
Dubbing with the built-in microphones
No connection is necessary.
Notes
•When you dub an audio sound with the external microphone, check the recorded
picture and sound by connecting the AUDIO/VIDEO jack to a TV. The recorded
sound is not output from the speaker. Check the sound by using the TV or
headphones.
•When you dub an audio sound with the AUDIO/VIDEO jack, check the recorded
picture on the LCD screen or in the viewfinder, as well as check the recorded sound
by using the speaker or headphones.
•When you dub an audio sound with the built-in microphone, check the recorded
picture on the LCD screen or in the viewfinder. The recorded picture is not output
from the AUDIO/VIDEO jack or the S VIDEO jack. Check the sound by using the
headphones.
Adding an audio sound on a recorded tape
(1) Insert your recorded tape into your camcorder.
(2) Set the POWER switch to VCR.
(3) Locate the recording start point by pressing N on the Remote Commander.
Then press X at the point where you want to start recording to set your
camcorder to playback pause mode.
(4) Press AUDIO DUB on the Remote Commander. The green X appears on the
LCD screen or in the viewfinder.
(5) Press
on your camcorder or X on the Remote Commander and at the
same time start playing back the audio you want to record.
The new sound is recorded in stereo 2 (ST2) during playback. During
recording new sound, the red appears on the LCD screen or in the
viewfinder.
(6) Press x on your camcorder or on the Remote Commander at the point where
you want to stop recording.
Audio dubbing
AUDIO DUB