Agilent Technologies System DC N5700 - Manual (Page 126)

Appendix D Compatibility
126 Series N5700 User’s Guide
Compatibility Command Description Similar SCPI
Command
OVP Sets the over-voltage trip point. VOLT:PROT:LEV
OVP? Queries the present over-voltage setting. The response is a real number. VOLT:PROT:LEV?
RCL <reg> Recalls the saved settings. There are up to 16 store/recall states. Saved
settings must have been previously stored using the STO command. *RCL
ROM? Queries the revision date of the power supply's firmware. *IDN?
RST Resets any tripped protection. OUTP:PROT:CLE
SRQ <setting> Generates error 203. The service request capability of the power supply is
only supported using the SCPI commands *SRQ
SRQ? Always returns 0. *SRQ?
STO <reg> Stores the present power supply settings in the specified register. There are
up to 16 store/recall states. *SAV
STS? Queries the present status. The response represents the sum of the binary
weights of the status register bits. The response is STS <n> STAT:OPER:COND?
STAT:QUES:COND?
TEST? Always returns 0. *TST?
TRG Causes the settings held with HOLD 1 to be executed.
UNMASK <setting> Sets the bits in the mask register to the setting. The setting is an integer
that represents the sum of the binary weights of the bits. The mask register
operates in conjunction with the status and fault registers. STAT:OPER:NTR
STAT:OPER:PTR
STAT:QUES:NTR
STAT:QUES:PTR
UNMASK? Queries the present setting of the mask register. The response is UNMASK
<n>. STAT:OPER:NTR?
STAT:OPER:PTR?
STAT:QUES:NTR?
STAT:QUES:PTR?
VMAX Sets the soft programming limit for voltage. Attempting to program the
voltage above this setting will generate an error.
VMAX? Queries the VMAX setting. The response is VMAX <n>.
VOUT? Queries the measured output voltage. The response is a real number. MEAS:VOLT?
VSET <voltage> Sets the output voltage. VOLT
VSET? Queries the present voltage setting. The response is a real number.
VOLT?