Sony MZ-N1 - Manual (Page 17)

17
3
Make connections and unlock the
control.
1 Connect the headphones/earphones
with the remote control to i/LINE OUT. 2 Slide HOLD to the direction of the arrow
(.) in the illustration to unlock the
controls.
z
You can also charge the battery by connecting
the AC power adaptor directly to the recorder.
Connect the AC power adaptor to DC IN 3V on
the recorder, and then flip the control bar
towards xCHG while the recorder is stopped.
Charge lamp lights up and charging starts. Full
charging takes about three and a half hours.
Charging is complete when charge lamp goes
off. Charging time may vary depending on the
battery condition.
Notes
• The supplied USB cradle can be used only
with this recorder. Any other models cannot
be charged.
• Do not use the supplied USB cradle to charge
any other battery besides the supplied one or
the one designated for it (NH-14WM(A)).
• Though the USB cradle, the recorder and the
battery may become hot during the charging
procedure, this poses no danger.
• Be sure to use the supplied AC power adaptor.
• If you are recharging the battery for the first
time or after a long period of disuse, the
battery may not charge up to its rated capacity.
This is a normal characteristic. After you use
and recharge the battery a few times, it will
return to its normal charge capacity.
• The rechargeable battery can be recharged
approximately 300 times.
• When the battery life of a fully charged
rechargeable battery becomes about half the
normal life, replace it.
• If the recorder will not be used for a long
period of time, disconnect the AC power
adaptor from a wall outlet and remove the
recorder from the USB cradle.
• The charge lamp will go off about three and a
half hours after you place the recorder on the
USB cradle. If you remove the recorder from
the USB cradle for 3 minutes or more while it
is charging, the charge lamp will go off and it
will take about three and a half hours for the
lamp to go off from the next time you place
the recorder on the USB cradle.
HOLD
Connect firmly
To i/LINE OUT
Connect firmly