Sony MZ-N1 - Manual (Page 90)

90
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BANK FULL • The character stored in the phrase bank has reached to 400.
, Delete some phrases from the name bank, and then reenter the
new phrase.
BLANKDISC • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a
few minutes).
Data Save • The MD player is recording information (sounds) from the
memory to the disc.
, Wait until this process is completed. Do not expose the player
to any physical shock, nor disrupt power supply.
DISC FULL • The remaining recording time on the disc is 12 seconds (SP
stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4
stereo), or less.
, Replace the disc.
EMPTY • You tried to erase data in the name bank but no data have been
recorded.
Hi DC in • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 72).
LINE OUT • You pressed VOLUME +/– while the “AUDIO OUT” parameter
was set to “LINE OUT.”
, Use the jog dial to set the “AUDIO OUT” parameter to
“HeadPhone” (page 27).
LOW BATT • Batteries are weak.
, Charge the rechargeable battery or replace the dry battery
(page 73).
MEM OVER • You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.
MENU • You pressed a key on the remote control while selecting a menu on
the recorder. You pressed a key on the recorder while selecting a
menu on the remote control.