Sony MZ-N1 - Manual (Page 68)

68
3
Turn the control repeatedly until
“ON” flashes in the display, and then
press
x to enter.
, lights up in the display and the
alarm sound can be selected.
4
Turn the control repeatedly to select
the alarm sound, and then press
x to
enter.
See step 4 of “On the recorder” for
the varieties of alarm sound.
5
Turn the control repeatedly to select
the elapsed time.
One rotation of the control changes
the elapsed time setting (TIME :) by 1
minute, within a range of 1 to 99
minutes. To change the time quickly,
turn and hold the control towards
. or N>.
6
Press x to enter.
The alarm is set.
The time remaining until the alarm is
shown in the display while the
recorder is stopped.
To check the time remaining
on the alarm while playing
Follow steps 1 to 3 on the recorder or
steps 1 to 4 on the remote control again.
The remaining time and the selected
sound appear in the display. Press
CANCEL on the recorder or press
DISPLAY for 2 seconds or more on the
remote control.
To cancel setting the alarm
• On the recorder
Press CANCEL.
• On the remote control
Press DISPLAY for 2 seconds or more.
To cancel Melody Timer
Select “OFF” in step 3.
To stop the alarm
Press any button. Note that the button’s
original function will not activate at this
time.
z
• If you end the procedure after step 3, the
previous alarm setting is automatically used.
• After sounding for one minute, the alarm will
automatically stop and the alarm setting will
be canceled. If the alarm sounds during stop
mode, then the power will automatically turn
off 10 seconds after the alarm stops. If the
alarm stops while an MD is playing, the
playback will continue uninterrupted.
Notes
• The settings will be lost when you start
recording.
• The timer will begin counting down (using the
factory setting) from the moment you select
“ON” in step
3 . The recorder will begin
counting down again from the moment you
change the elapsed time in step 5.