Sony MZ-N1 - Manual (Page 91)

91
NAME FULL • You tried to enter more than 200 letters to label a single track,
group, or disc.
• You tried to enter a total of more than approximately 1,700 letters
for track or disc names.
, Enter a shorter name for the track, group, or disc (page 50), or
set the “LP Stamp” setting to “Stamp OFF” so that “LP:” is not
added at the beginning of the track name (page 30).
NO BATT • The rechargeable battery is not inserted.
, Insert a rechargeable battery.
NO COPY • You tried to make a copy from a disc that is protected by the Serial
Copy Management System. You cannot make copies from a
digitally connected source which was itself recorded using digital
connection.
, Use analog connection instead (page 29).
NO DISC • You tried to play or record with no disc in the recorder.
, Insert an MD.
No Entry! • You tried to erase a setting in the Personal Disc Memory on a disc
that contains no settings in the Personal Disc Memory.
NO SIGNAL • The recorder could not detect digital input signals.
, Make sure that the source is connected firmly (page 20).
P/B ONLY • You tried to record or edit on a pre mastered MD (P/B stands for
“playback”).
, Insert a recordable MD.
PROTECTED • You tried to record or edit on a MD with the tab in the record-
protect position.
, Slide the tab back (page 75).
REC ERR • Recording was not correctly done.
, Place the recorder at a place with no vibrations and record
again.
• The disc is soiled with an oil film or finger prints, is scratched, or
is not a standard disc.
, Try recording again with another disc.
READ ERR • The recorder cannot read the disc information correctly.
, Reinsert the disc.
Error message Meaning/Remedy