Alliance Laundry Systems PHM1263R - Manual (Page 52)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Testing Machine and Electronic Control Functions
F8208801 50
Production Test Cycle Quick Reference Chart
Display Test Cycle Step Comments
“S xx” FEC Control Software
Version xx is the software version number.
“o xx” Output Board Software
Version xx is the software version number.
“Ct 3” Control Type xx is the control type.
“oPL” Control Type OPL.
“USA” Control Type Domestic
“drAn” or “PUnP” Drain Type Drain or Pump.
“tEnP” Temp Sensor Step skipped if not Temperature Sensor-equipped.
“HEAt” Heater Step skipped if not heater-equipped.
“rot” Rotation Sensor Step skipped if not Rotation Sensor-equipped.
“L dC” or “L AC” Door Lock Type “L dC” if 24 VDC lock or “L AC” if 240 VAC unlock solenoid.
“droP” or “drCL” Door Status Door open or closed.
“drUL” or “drLo” Door Lock Status Door will lock.
“8.8.8.8.” + all LEDs Display Test All display elements are lit.
“PAxx” where xx = 1
through 12 Keypad Test step Advance after all keypads are pressed.
“A xx” Top Cover Switch Test xx is either “CL” for closed or “oP” for open.
“Cxxx” or “Pxxx” Machine Type/Size
“drxx” Drive Software Version
Number xx is the drive software version number. Design 4 models only.
“dPxx” Drive Parameter Table
Version Number xx is the drive parameter table version number. Design 4 models
only.
“dt x” Drive Type Value xx is the drive type value. Design 4 models only.
“HFIL” Hot Fill to Low Level All water outputs turned off when Low Level reached.
“CFIL” Cold Fill to Low Level All water outputs turned off when Low Level reached.
“bFIL” Warm Fill to Low Level All water outputs turned off when Low Level reached.
“bFIH” Warm Fill to High Level All water outputs turned off when High Level reached.
“S1” Supply #1
“S2” Supply #2
“S3” Supply #3
“S4” Supply #4
Table 16 (continued)