Alliance Laundry Systems PHM1263R - Manual (Page 9)

7 F8208801 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display Identification
Light Emitting Diodes (LEDs)
(Refer to Figure 1)
Light Emitting Diodes (LEDs) are used to indicate the
chosen cycle, cycle status, when the bleach
compartment is dispensing, and door lock information.
See below for information on each LED.
WASH LED
Wash LED is lit at the beginning of a wash portion of
the cycle and will remain lit until the wash is
complete.
RINSE LED
Rinse LED is lit at the beginning of a rinse portion of
the cycle and will remain lit until the rinse is complete.
SPIN LED
Spin LED is lit during the Final Spin portion of the
cycle.
DOOR LED
Door LED is lit whenever the door is locked.
Four 7-Segment Digits
The 7-Segment Digits are used to display the time
remaining in a cycle, error messages and descriptive
codes. During diagnostic testing or manual
programming of the control, these digits will display
descriptive codes and values (as described in Entering
the Manual Mode).