Vaddio AutoTrak 2.0 User Manual
Page 10
AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 10 of 52
Belt Pack Dip Switch Settings:
Belt Pack Configuration Settings:
The Belt Pack has a number of custom settings that can be enabled or disabled for specific applications.
These settings can be applied by activating dip switch settings on the two (2) 4-position dip switches SW4
and SW5 located on the Belt Pack Circuit Board.
Switch Set 4:
SW4: Dip Switch 1 - Not Used
SW4: Dip Switch 2 - IR Transmitter: ON enables the IR Transmitter LED’s in the IR Lanyard. OFF
disables the IR Transmitters in the Lanyard and the camera tracking will not function.
SW4: Dip Switch 3 - Radio in Belt Pack: ON enables the Radio circuit in the Belt Pack. OFF
disables and will turn off the Radio circuit to increase battery life. Make sure this switch is in the ON
position for use with Audio Interface (if applicable). It ships from the factory in the OFF position.
Note: Turn OFF Dip Switch 3 when not using the optional EasyTalk AutoTrak 2.0
Wireless Audio Interface with the AutoTrak 2.0 System.
SW4: Dip Switch 4 - Clear Pairing: ON clears the pairing setting of the receiver in the Belt Pack.
.
Switch Set 5:
SW5: Dip Switch 1 - 3dB Gain Boost: Enable adds a three (3) dB gain to the microphone audio.
Disable provides zero gain.
SW5: Dip Switch 2 - 6dB Gain Boost: Enable adds a six (6) dB gain to the microphone audio.
Disable provides zero gain.
SW5: Dip Switch 3 - 9dB Gain Boost: Enable adds a nine (9) dB gain to the microphone audio.
Disable provides zero gain.
Note: The following Gain Boost Switches, 1 through 3, can be used individually or in
combination. For example, if Dip Switch 1, 3dB Gain and Dip Switch 2, 6dB Gain are
both ON, they will add a total of 9 dB of gain
SW5: Dip Switch 4 - Automatic Gain Control: ON enables an Automatic Gain Control function that
maintains a constant audio level to regulate soft talkers as well as loud talkers. OFF disables the
Automatic Gain Control, of course.
Optional: AutoTrak 2.0 Wireless Audio Interface for AutoTrak 2.0 Systems:
Switch
Number
Dip Switch Function
Switch Set 4
1 Not
Used
2
ON/OFF - IR LED’s in Lanyard
3
ON/OFF - Radio in Belt Pack *Turn off when not
using Optional EasyTalk Wireless Receiver
4
Clear Pairing (pairing is required for proper operation)
Switch Set 5
1
ON/OFF: ON adds 3dB Gain Boost on Microphone
2
ON/OFF: ON adds 6dB Gain Boost on Microphone
3
ON/OFF: ON adds 9dB Gain Boost on Microphone
4
ON/OFF: Automatic Gain Control Mode
SW3
SW4
SW5