Vaddio AutoTrak 2.0 - Manual (Page 12)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 12 of 52
Optional: AutoTrak 2.0 Wireless Audio Interface/Rear Panel Connections
1) 12 VDC, 1.0 Amp Power Connector: The 5.5mm OD and 2.5mm ID power connector should be
plugged into the PowerRite power supply provided by Vaddio. Use of any unauthorized power
supplies will void any and all warranties.
2) RS-232 Control: The DB-9 female connector is provided for 3
rd
party control systems using the
Wireless Audio Interface Application Protocol Interface (API). See the Command List.
3) Settings (8-Position Dip Switch): The eight position dip switch is used for system configuration of
the AutoTrak 2.0 Wireless Audio Interface:
 Dip Switch 1 - Compressor: Enable adds a Dynamic Range Compressor for the Audio Line
Level Outputs (balanced or unbalanced). Disable turns it off.
 Dip Switch 2 - Speaker EQ Filter: Enable adds a specialized output filter for improved
intelligibility for voice applications. Disable turns it off.
 Dip Switch 3 - ON Position/USB Conference Mode: Enable (Dip Switch 3 On) creates the
desired audio mixing (Near and Far ends) for USB conferencing applications such as Skype.
Disable turns off the USB Conference Mode.
o
Note: In the USB Conference Mode, the PC USB Speaker Audio is sent to the balanced and
unbalanced audio line outputs, which allows the Far End Audio to be presented in the room.
The Belt Pack Wireless Microphone Audio is also sent to the PC to send to the Far End.
o The AutoTrak 2.0 Wireless Audio Interface will also be recognized as a USB Audio Device by
the PC with recording (the Belt Pack Wireless Microphone Audio) and playback (the Speaker
Audio) capabilities. Disable turns the USB Conference Mode off.
 Dip Switch 3 - OFF Position/USB Record Mode: Disable (Dip Switch 3 Off) creates a USB
Record Mode for PC Audio Recording (PC requires Audio Recording Software-not included) and
Playback through the USB port (Audio output through the Balanced or Unbalanced Audio Line
Outputs).
o
The AutoTrak 2.0 Wireless Audio Interface will be recognized as a USB Audio Device by the
PC with recording (the Belt Pack Wireless Microphone Audio) and playback (the Speaker
Audio) capabilities.
 Dip Switch 4 - Radio ON/OFF: ON enables the Radio Receiver for the Wireless Microphone on.
OFF turns it off, naturally.
 Dip Switch 5 - Baud Rate Selection ON/OFF: OFF sets the Baud Rate to the default 9600bps.
ON sets the Baud Rate to 38400bps.
 Dip Switch 6 - Front Panel Buttons Lock ON/OFF: ON locks the Front Panel Buttons and
disables the buttons from functioning. OFF allows the front panel buttons to be used.
 Dip Switch 7 - Software Control ON/OFF: When ON, dip switches 1, 2, 3, 4, and 8 are ignored
to allow full serial control of the audio interface
 Dip Switch 8 - Resets to Factory Defaults ON/OFF: When ON and power is plugged in, the
interface is set to factory defaults. Leave OFF for normal operation.
① ② ③ ④ ⑤ ⑥ ⑦