Vaddio AutoTrak 2.0 - Manual (Page 8)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 8 of 52
Belt Pack Control Panel
1) Lanyard Cable Connector (5-pin mini XLR - M): Plug the cable attached to the Lanyard into
the mini XLR connector to allow audio to be received by the Belt Pack and for power to be
provided to the IR LEDs in the Lanyard.
2) Radio: This LED indicates an active radio link with the EasyTalk AutoTrak 2.0 Wireless Audio
Interface. Solid blue LED indicates connection with the AutoTrak 2.0 Wireless Audio Interface.
Flashing blue LED indicates radio link has been lost.
Note: Radio link operates up to 100 feet line of sight of the AutoTrak 2.0 Wireless Audio
Interface.
3) System Power: To use the Belt Pack or IR Lanyard, turn the SYSTEM POWER switch to the on
position and the LED will illuminate. Be sure to turn off the SYSTEM POWER switch when the
system is not in use to save the battery life. The Rechargeable Lithium Ion Battery Pack provides
up to ten (10) hours with full charge.
Note: It is highly recommended that the Rechargeable Lithium Ion Battery Pack be
fully charged prior to using the Belt Pack for the first time!
4) Microphone ON/OFF: This switch turns the wireless microphone on or off at the Belt Pack
allowing the presenter to use an existing room system microphone instead, or for momentary
microphone muting.
Note: The System Status light on the EasyTalk AutoTrak 2.0 Wireless Audio Interface will light if
the microphone signal is detected. If the Microphone is turned off at the Belt Pack, the System
Status light will not light.
5) 1” ¼-Wave Antenna: Used to transmit the wireless microphone audio back to the AutoTrak 2.0
Wireless Audio Interface.
①
②
③ ④
⑤