Vaddio AutoTrak 2.0 - Manual (Page 39)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 39 of 52
HD Video Select:
This rotary switch sets the HD YPbPr video output resolution. Use the resolution that works well with the
peripheral equipment (monitors, codecs, video mixers, etc.) Not all monitors can handle all the
resolutions on this table. Please choose the resolution that best serves your peripheral equipment.
Finding the sweet spot can be a bit of a challenge due to the scalers built in to cameras, monitors, video
mixers and video processors.
AutoTrak 2.0 HD-18 Dip Switch Settings:
 IR 1, 2 & 3: These settings, using switches 1 & 2, determine the IR frequency of the one IR remote
control that was supplied with your system. The IR remote can operate up to three different PTZ
cameras from one remote, using the selector buttons at the top of the remote. Do not set the same IR
number for both cameras!

* IR Out: Leave this switch in the ON position on both the IR Reference and Tracking cameras
for use with AutoTrak 2.0. When this switch is in the ON position, the IR Remote is overridden.
 Baud Rate: The options for baud rate are 9600 or 38,400 for RS-232. Set to 9600bps for AutoTrak
2.0.
 SD Output Frequency: Select either NTSC or PAL as the output for the camera’s SD signal that is
transmitted on the BNC connector. For North America, for the IR Reference camera set to NTSC for
the AutoTrak 2.0. For International systems, use the PAL setting
 SD Output Size: Three options are available for the SD output, select from crop, squeeze or letterbox.
Set this parameter accordingly to the peripherals used.
 Image Flip: Turning Image Flip on (switch down), will flip the image and allow the camera to be
inverted. For AutoTrak 2.0, set image flip to OFF.
 Test Bars: Turning this switch on will override the camera video output and send non-standard 75%
test video bars from the camera output. The test color bars are intended as a convenience for testing
the signal path and for use with the HD-18 CCU System and diagnostics of configuration cabling.
 Switch 10: This switch is unused, and should be left in the OFF position.
AutoTrak 2.0 HD-20 Switch Settings:
These switch settings must be set in accordance with the peripherals used in the system. For the
AutoTrak 2.0, the required settings are noted. On the bottom of the camera there is a label that defines
the 10-positon dip switch functions and the rotary HD/YPbPr Video Select switch.
HD Video Select:
This rotary switch sets the HD YPbPr video output resolution. Use the resolution that works well with the
peripheral equipment (monitors, codecs, video mixers, etc.) Not all monitors can handle all the
resolutions on this table. Please choose the resolution that best serves your peripheral equipment.
Finding the sweet spot can be a bit of a challenge due to the scalers built in to cameras, monitors, video
mixers and video processors.
HD Video Select Switch Camera Settings 10-Pos Dip Switch
HD-20
Rear
Panel