Vaddio AutoTrak 2.0 - Manual (Page 11)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 11 of 52
998-7230-000: EasyTalk AutoTrak 2.0 Wireless Audio Interface-North America
998-7230-001: EasyTalk AutoTrak 2.0 Wireless Audio Interface-International
 Front Panel Controls
1) Power ON/OFF: This switch turns the power for the AutoTrak 2.0 Wireless Audio Interface on or off.
To use, push the power button until the blue LED is lit and the system is ready for operation.
2) Pair: This button initiates the automatic pairing (Pairing is the matching of the same Adaptive
Frequency Hopper AFH hopping sequence for both devices) for the Belt Pack Radio Transmitter and the
AutoTrak 2.0 Wireless Audio Interface Radio Receiver in the AutoTrak 2.0 Wireless Audio Interface.
3) Mute: This control mutes (turns off) the audio outputs of the AutoTrak 2.0 Wireless Audio Interface.
4) Volume: The + (plus) and – (minus) buttons are used to raise and lower the audio outputs (Balanced
and Unbalanced) from the AutoTrak 2.0 Wireless Audio Interface.
5) Audio Level: This LED display will indicate the relative audio level output (from all sources) of the
AutoTrak 2.0 Wireless Audio Interface. Red Line at the top of the LED Display indicates clipping of the
audio signal.
6) Radio, EQ Filter and Compressor Status LED’s:
 Radio LED: Solid blue light indicates normal operations. Fast flashing indicates no link
established with the Belt Pack Wireless Microphone. Slow flashing indicates the Pairing cycle is in
progress.
 EQ Filter: Blue light on indicates the EQ Filter is turned on. Blue light off indicates the EQ Filter is
off. When EQ Filter is enabled, it helps increase speaker intelligibility for voice applications.
 Compressor: Solid blue light indicates that the Compressor is on. No light indicates that the
Compressor is off. Compressor on minimizes the potential of “clipping” by attenuating the audio
signals that exceed the maximum output levels.
7) Antenna: The 4” antenna is tuned to receive 2.4 GHZ signals from the IR Lanyard Belt Pack
Microphone. Note: If the AutoTrak 2.0 Wireless Audio Interface is installed deep inside a metal
equipment rack or is surrounded by other metal cased equipment, the antenna may need to be
extended away from the rack to improve reception.
Optional Antenna Extension Kit
The Audio Interface has an Optional Antenna Extension Kit available which will add
approximately 6dB gain to the system and extend the front panel receiver antenna to a
base antenna that would sit on top of the rack. It also includes a longer ½ wave whip
RP-SMA antenna for the belt pack.
See part number: 999-1234-000.
① ② ③ ④ ⑤ ⑥ ⑦
Optional Antenna
Extension Kit