Vaddio AutoTrak 2.0 - Manual (Page 7)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 7 of 52
The IR Lanyard and Belt Pack for use with the AutoTrak 2.0 Camera Tracking Systems:
999-7250-000 and 999-7260-000 North America
999-7250-001 and 999-7260-001 International
1) IR Lanyard: Cloth covered flat flex circuit with IR LEDs terminates at the Central Medallion
2) Central Medallion: Supplies a connection point for the flat flex cable, contains an integrated
condenser microphone and a rubber over-molded cable strain relief that attaches the 32” cable.
3) 32” (813mm) Cable: Terminates the Central Medallion to the Belt Pack with a 5-Pin Mini XLR-F
connector.
4) Belt Pack: Holds power circuitry, wireless microphone transmitter, transmitter frequency control
switches (see pages 6-7) and rechargeable lithium battery pack.
5) Belt Pack Front Panel Controls: The System on/off controls and LED indicator as well as the
Microphone on/off controls are located on the Belt Pack Control Panel (see page 6-7).
6) Belt Clip: To clip the Belt Pack on a belt like device that the presenter wears.
7) Antenna: 1” (25.4mm) ¼-wave RP-SMA straight antenna to transmit RF wireless audio at 2.4 GHZ
utilizing Adaptive Frequency Hopper (AFH) from the integrated unidirectional microphone element.
The Lanyard’s Central Medallion Clothing Clips:
The system is shipped with two types of clothing clips to keep the
unidirectional mic built-in to the medallion facing the right direction and
keep it from flopping around when the presenter moves their hands and
arms to make a point.
1. A Triple Circle Magnet is a 2-piece magnetic kit meant to attach the
central medallion to the presenter’s clothes with magnets.
 Peel off the adhesive backing cover and place the metal plate to the
back of the medallion and push to make good contact
 Place the Central Medallion next to the clothing (shirt or dress) and
from the back side of the clothing attach the magnet. The magnet
will hold the medallion firmly against the clothing.
Note: Please do not use the magnet solution if the presenter
has a pacemaker or implantable cardioverter-defibrillator (ICD).
Magnets can negatively affect the operation of these medical
devices. The magnet side is labeled with a caution to warn the
user. Use only the Cable Clip for pacemaker and ICD patients
2. Additionally, an Audio-Technica AT8439 Cable Clip is also included.
This clip for clothing is a small and is to be attached to the cable just
below the central medallion’s cable strain relief. The clip will hold the
medallion firmly to the clothing
①
② ③
④
⑤
⑥
⑦
Note: Do not fold the Lanyard Necklace at any time as it contains a
flexible circuit that may cease to work if the necklace is hard folded.
Attach Cable
Clip to a point
just below the
strain relief.
Attach metal plate
with the adhesive
backing to the back of
the medallion. Use
the triple magnets to
attach trough clothing.