Vaddio AutoTrak 2.0 - Manual (Page 28)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 28 of 52
All Menu Screen Shots and Control Descriptions (continued):
Tuning: Algorithm
Control Action Description
Luminance Threshold Click Up/Down Minimum illumination to be considered a valid target (1-255)
Max Luminance Density Slider Left/Right Max luminance points to be considered a valid target (1-9999)
Top Image Area Ignored Click Up/Down Number of lines from the top of the image the IR reference camera
will ignore. Used when there are other IR emitters in the upper part
of the camera’s view, to improve camera tracking. (Range 0-45%,
Default = 0%)
Bot Image Area Ignored Click Up/Down Number of lines from the bottom of the image the IR reference
camera will ignore. Used when there are other IR emitters in the
lower part of the camera’s view, to improve camera tracking. .
(Range 0-45%, Default = 0%)
Search Left Limit Click Up/Down The Left most location, in degrees, to search for target.
Search Right Limit Click Up/Down The Right most location, in degrees, to search for target.
Move Left Limit Click Up/Down The Left most location, in degrees, camera can move.
Move Right Limit Click Up/Down The Right most location, in degrees, camera can move.
Search Pan Speed Click Up/Down Pan search speed and max tracking camera speed
Search Tilt Position Click Up/Down Reference camera tilt angle, in degrees
Projection Time Click Up/Down Tracking speed adjustment where higher value reduces speed.
Window Width Click Up/Down Wider Window Width reduces left-right movement. Narrow Window
Width increases the left-right movement of the camera
Window Height Click Up/Down Greater window height reduces up-down movement. Narrow window
height increases up-down movement of the camera. (Range 1-60%,
Default = 20%)
Max Blind Time Click Up/Down Time, in sec, to wait after target loss to begin target re-acquisition
Max. Reacquisition Time Click Up/Down Time, in sec, to search for target before going into standby mode.
Load Button Click/Press Load all tuning setting
Save Button Click/Press Save all tuning setting
Pause/Resume Button Click/Press Pause or Return to Tracking
Shutdown Button Click/Press Close/Shutdown system