Vaddio AutoTrak 2.0 - Manual (Page 40)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 40 of 52
Switch Setting Label on the Bottom of the HD-20 (slightly different than the HD-18)
 Set the HD output resolution for the camera with the Rotary Switch.
AutoTrak 2.0 HD-20 Dip Switch Settings:
 IR 1, 2 & 3: These settings, using switches 1, 2 and 3 determine the IR frequency of the one IR
remote control that was supplied with your system. The IR remote can operate up to three different
PTZ cameras from one remote, using the selector buttons at the top of the remote.
 IR Out 4:
* IR Out: When this switch is in the ON position, the IR Remote is overridden.
Leave this switch in the ON position on both the IR Reference and Tracking cameras for
use with AutoTrak 2.0.
 Baud Rate 5: The options for baud rate are either 9600 bps or 38,400 bps
Set to 9600bps for AutoTrak 2.0.
 Image Flip 6: To invert the HD-20, turn the IMAGE FLIP ON (switch down).
For AutoTrak 2.0, set image flip to OFF.
 HDMI Color or sRGB Color space 7: Default is YCbCr. Use sRGB color space with older DVI-D
1.0 monitors only. The YCbCr color space is best for HDMI digital video.
 Switches 8, 9 and 10: Leave up - or in the OFF position
IR 2
ON
IR 1
ON
1
38400
bps
4
IR
OUT
ON
2
IR 3
ON
3 5 5 4 8 6 7 7 6 8
IR 2
OFF
IR 1
OFF
DIP SWITCH SETTINGS
9600
bps
IR
OUT
OFF
IR 3
OFF
HDMI
COLOR
YCbCr
IMAGE
FLIP
OFF
B 3
7
6
5
4
9 10 10 9
F
E
D
C
VIDEO SELECT
2
0
1080p/30
1 1080i/59.94
720p/59.94
A
9
8
10
OFF
8
OFF
9
OFF
1080p/25
1080i/50
720p/50
ON
1080i/60
720p/60
sRGB
*