Vaddio AutoTrak 2.0 - Manual (Page 35)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 35 of 52
Rear View of HD-18
5) RS-232 In & IR Out:
The RS-232 accepts modified Canon control protocol for camera control.
6) DIP Switch Settings:
Settings for IR remote, baud rate, SD output format, image flip can be configured on these switches. See
Pages 39-40 for additional information switch settings.
7) HD Video Select:
A rotary switch allows the user to choose the component HD output video resolution and format. See
Page 39-40 for additional information on switch settings.
8) 12 VDC Input
NOTE: The power input is not used with the AutoTrak 2.0 system. This is only used on the standard,
ClearVIEW HD-18 camera.
9) YPbPr Video Output:
Component HD video is fed through the DB-15 connector.
10) SD Video Output:
Standard definition video is fed through the BNC connector.
11) EZ Power Video Port:
CAT-5e cable is connected to the Quick-Connect DVI/HDMI SR Interface. The EZ Power Video Port
supplies power to the camera and returns component HD video up to 100’ (30.5 m)’.
12) Slot for Optional Cards
Optional slot cards can be plugged into the WallVIEW HD-18 camera through the slot in the back of the
camera base.
⑤
⑥
⑧
⑦
⑨
⑫
⑩
⑪