Vaddio AutoTrak 2.0 - Manual (Page 37)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 37 of 52
7) HD Video Select:
A rotary switch allows the user to choose the component HD output video resolution and format. See
Pages 40-41 for additional information on switch settings.
8) 12 VDC Input
NOTE: The power input is not used with the AutoTrak 2.0 system. This is only used on the standard,
ClearVIEW HD-20 camera.
9) HDMI Output:
The HDMI output feeds out HD digital video only (no copy protect or device communication is included).
SD is not supported
10) YPbPr Output:
Component HD video is fed through the DB-15 connector. YPbPr and HDMI signals are simultaneous.
SD is not supported
9) EZ Power Video Port:
CAT-5e cable is connected to the Quick-Connect DVI/HDMI SR Interface. The EZ Power Video Port
supplies power to the camera and returns component HD video up to 100’ (30.5 m)’.
10) Slot for Optional Cards
Optional slot cards can be plugged into the WallVIEW HD-20 camera through the slot in the back of the
camera base.
HD-18 used as the IR Reference Camera:
The AutoVIEW 2.0 HD-18 camera is the only camera
that is used for the IR Tracking Camera. The features
of the HD-18 and the sensitivity of the image sensor
make the HD-18 an ideal choice for tracking the IR
Lanyard.
The IR Reference HD-18 is equipped with the following
adapters and filters:
 One (1) 37mm female lens ring adapter attached to
HD-18 Camera
 One (1) 37mm to 58mm adapter ring
 One (1) 58mm polarizing filter
 One (1) 58mm band-pass IR filter
HD-18 with Adapters
and Filters Attached