Vaddio AutoTrak 2.0 - Manual (Page 48)

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 48 of 52
Compliance and CE Declaration of Conformity: EasyTalk AutoTrak 2.0 Wireless Audio Interface
Compliance testing was performed to the following regulations:

FCC Part 15 Subpart B

FCC Part 15, Subpart C Section 15.247 Class A
 FCC Part 15, Subpart C Section 15.207 Class A
 Industry Canada RSS-210 Issue 8 Class A
 Industry Canada RSS-Gen Issue 3 Class A
 IEC 60950-1/A1: 2009 Safety

ETSI EN 300 328 V1.7.1 Class A

EN 55022 A: 2010 (CISPR 22, 2008, Modified) Class A
 ICES-003, Issue 4: 2004 Class A
 EN 55022 A: 2010 Class A
 AS/NZS CISPR 22: 2009 +A1:2010 Class A

VCCI V-3/2011.04 Class A

EMC Directive 2004/108/EC Class A
FCC Part 15 Subpart B, Subpart C, Section 15.249 Compliance and Industry Canada RS-210
Compliance

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15, Subpart C
of the FCC Rules and RS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his/her own expense.

Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must
accept any interference including interference that may cause undesired operation of the device.
 Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s
authority to operate this equipment.

Do not use any antenna other than the one provided on the unit.

This equipment complies with the FCC/IC radiation exposure limits set forth for portable transmitting devices operating in an
uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance
ICES-003 Compliance
ICES-003, Issue 4: 2004
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux appareils numeriques de
la classe B préscrites dans le Règlement sur le brouillage radioélectrique édicte par le ministère des Communications du Canada.
European Compliance
This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and Immunity and meets
the requirements for a Class A digital device. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
Standard(s) To Which Conformity Is Declared:
EMC Directive 2004/108/EC
 EN 55024: 2010
 EN 61000-4-2: 2009

EN 61000-4-3: 2006 + Amendments A1: 2008 + A2: 2010

EN 61000-4-4: 2004 + Corrigendum 2006

EN 61000-4-5: 2006
 EN 61000-4-6: 2009
 EN 61000-4-8: 2010
 EN 61000-4-11 Second Edition: 2004
Radio and Telecommunications Terminal Equipment Directive 1999/5/EC
 ETSI EN 301 489-17 V2.1.1: 2009 referencing ETSI EN 301 489-1 V1.2.1: 2008

EN 61000-4-2: 2009

EN 61000-4-3: 2006 + Amendments A1: 2008 + A2: 2010

EN 61000-4-4: 2004 + Corrigendum 2006
 EN 61000-4-5: 2006
 EN 61000-4-6: 2009
 EN 61000-4-11 Second Edition: 2004

ISO 7637-2 Second Edition: 2004 + Amendment A1: 2008 - Test not applicable for base station equipment