Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 13)

Rev. 5/12 Page 13 of 15 SB
11634.10
Step 34. Cut out the rear fender in the order shown.
Starting with #1 area trim the 3/8 inch lip
from the fender. Area’s # 2, 3 only trim
down to the body moulding area. Area
# 5 only cut the outer skin in this area.
See next steps for areas # 4, 5. Repeat for
opposite side.
Step 35. Cut area # 4 carefully. Start by cutting
3/8 inch from the line and grind the rest
of the way. A filler putty or silicone is
needed to fill the gap between the
sheet metal. Repeat for opposite side.
Step 36. Cut area # 5 in steps. Trace a line
following the contour of the raised flare
out of the body. Trim only the outer skin
in the area outlined. The remaining
area should be cut through both layers
and removed. Repeat for opposite side.