Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 5)

Rev. 5/12 Page 5 of 15 SB
Step 12. Begin trimming the marked areas. Use
of an air saw or grinder will be needed.
You must wear eye and ear protection
when cutting metal. Gloves should be
worn when handling sharp metal. Use
caution when cutting metal. Do not over
cut. Ensure the are no obstructions on
the back side of the metal being cut.
11634.10
Step 10. Starting at the mark made in the previous
step draw a line upward following the
contour of the raised area on the fender
to the top of the third factory bolt hole.
Repeat for opposite side.
Step 11. Draw a horizontal line from the contour
line inward towards the wheel well at
the top of the third bolt hole. Repeat for
opposite side.