Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) User Manual

Page 9

Advertising
background image

Rev. 5/12

Page 9 of 15

SB

11634.10

Step 22. Once fitment is complete hold the flares

in place and mark the mounting holes on

the body using the pre-drilled holes in

the flare as a guide.

Step 23. Drill the mounting holes using a 3/16”

drill bit.

Step 24. Clean inside mounting lip edge with

rubbing alcohol. Install edge trim as

shown by removing red vinyl tape

covering only a few inches at a time.

Do not stretch the trim while being

applied, this may cause shrinkage after

installation.

Advertising