Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 7)

Rev. 5/12 Page 7 of 15 SB
11634.10
Step 16. Bare metal must be treated. A primer
surfacer is recommend before painting.
Step 17. Re-install the front wheel well liners. Mark
the front of the liner with a horizontal line
starting from the headlight bezel going
towards the wheel well. Next trace a line
following the cut portion of the fender
onto the wheel liner. Trim this area out.
Do not trim below the front of the fenders
near the bumper, this will be done in the
next step.
Step 18. Fold the wheel well liner flap forward
near the front bumper. Draw a line on the
inside of the liner from the corner of the
fender by the marker light diagonally
down to the outside of the first mounting
hole. Trim on the line that was created. It
may be necessary to secure the front area
of the liner to the inside of the wheel well.