Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 3)

Rev. 5/12 Page 3 of 15 SB
Step 4. Carefully remove all emblems from the
front fenders. Use of a putty knife may be
needed. Use caution when removing to
prevent damage to the paint. All adhesive
will need to be removed before the
flares are attached to the vehicle.
Step 5. Draw a horizontal line on the front fender
starting at the bottom of the front
headlight bezel continuing to the edge of
the fender well. Repeat for opposite side.
Step 6. Using the line previously drawn measure
5 Inches in towards the wheel well starting
from the headlight bezel and place a mark.
Repeat for opposite side.
11634.10
Note:
1984-1996: Require steps 5 thru 8 for cutting front
fenders.
1997-2001: Do not require cutting.