Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 10)

Rev. 5/12 Page 10 of SB
Step 27. Place the flare against the body and align
the screws into the drilled holes in the
body. Tighten the screws. Do not torque
over 24 inch pounds.
11634.10
Step 25. Clean inside mounting lip edge with
rubbing alcohol. Install edge trim as
shown by removing red vinyl tape
covering only a few inches at a time.
Do not stretch the trim while being
applied, this may cause shrinkage after
installation.
Step 26. Place a washer on each bolt and insert
them into the pre-drilled holes in the
flare. Place a rubber spacer on each bolt
on the inside of the flare.