Rugged Ridge All Terrain Fender Flare Kit, 4-Door, 84-01 Jeep Cherokee (XJ) - Manual (Page 14)

Rev. 5/12 Page 14 of 15 SB
11634.10
Step 37. Fold the metal flap created to close the
gap between the inner and outer sheet
metal. All edges should be smoothed
and free of burrs. All exposed metal must
be treated before flares are installed. A
filler putty may be used to seal the area.
Repeat for opposite side.
Step 38. Install the dog leg shaped trim piece on
the door edge. At the rear door opening
fit the trim against the body. Secure the
trim in place with the supplied self
tapping screws. Use the dimples in the
plastic as guides for the screws. Do not
overtighten. Repeat for opposite side.
Note: Depending on the model and year of the
vehicle the body trim will vary. On newer
models it may be necessary to trim the
flare to fit over the body moulding.
Step 39. Refer to steps 19 thru 27 for flare
mounting procedures.