Festo Контроллер крайних положений SPC11 - Manual (Page 128)

A. Start-up via digital inputs/outputs
A-6
Festo P.BE-SPC11-SYS-EN en 1406e
A.2.1 Setting time-dependency diagram parameters
I7: {/-
1
0
1
0 I1...4:
Po.1...4
1
0
1
0
I8: Remote
1
0
I6: Enter
min. 2 s
1 2 3
I5: +/}
1
0
1 2 99
1 2 n
4
min. 20 ms
min. 20 ms
min. 20 ms
min.
20 ms
O5:
Error/Ready *)
*) Function of the O5 output can be configured (see chapter 4.2.3); Error (factory setting) or Ready
1 Activate modification mode
2 Reset parameter A to 0
3 Set parameter value A
4 Confirm parameter value A
(switch-on time min. 2 s)
Fig. A/2: Set time-dependency diagram parameter A
After confirmation of the parameter value A, the next para-
meter can be set (see Fig. A/1). After confirmation of the last
parameter, the teach procedure is simultaneously initiated
and can then be started (see Fig. A/3).