Festo Контроллер крайних положений SPC11 - Manual (Page 57)

3. Installation
3-29
Festo P.BE-SPC11-SYS-EN en 1406e
3.3.3 Connecting the proportional directional control valve and the
measuring system
Connecting the measuring system
Use only the permitted combinations of drives and measuring
systems approved of by Festo for the SPC11. The connecting
cable for the measuring system is connected either fixed to
the SPC11 or to the drive.
Note
Interference due to electromagnetic influences can be
avoided if a short cable is used. Use only the original
cable.
Observe also, where applicable, the operating instructions for
the measuring system.
Fasten the plug with the aid of the integrated screw, in order
to prevent unintentional loosening, e.g. due to shock.
Connecting the proportional directional control valve
The valve connection provides the power supply for the valve
and the control voltage for positioning the valve slide.
Use only the original cable for connecting the valve.
Type designation Cable length
KMPYE-AIF-1-GS-GD-2 2 m
KMPYE-AIF-1-GS-GD-0,3 0.3 m