Lenovo ThinkServer TD200x - Manual (Page 116)

1 USB 1 7 Power-error LED
2 USB 2 8 dc-power LED
3 USB 3 9 ac-power LED
4 USB 4 10 Video
5 Ethernet 10/100/1000 11 Serial 1 (COM 1)
6 Power cord connector 12 Systems management
Updating the server configuration
When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup Utility
starts automatically so that you can save the new configuration settings. For more
information, see Chapter 6, “Configuring the server,” on page 103.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
The server comes with at least one microprocessor. If more than one
microprocessor is installed, the server can operate as a symmetric multiprocessing
(SMP) server. You might have to upgrade the operating system to support SMP. For
more information, see “Typical operating system installation” on page 117 and the
operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
100 ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide