Lenovo ThinkServer TD200x - Manual (Page 88)

Removing an adapter
1 Rear adapter retention bracket
2 Adapter
3 Front adapter retention bracket
To remove an adapter, do the following:
1. Read the safety information that begins on page vii and “Handling
static-sensitive devices” on page 39.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 42).
5. Rotate the adapter retention brackets to the open position.
6. Disconnect the cables from the adapter.
7. Remove the screw that secures the adapter to the server chassis.
8. Pull the adapter out of the adapter connector; then, lift the adapter out of the
server.
9. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing an adapter
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
72 ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide