Konica Minolta BIZHUB 223 - Manual (Page 143)

bizhub 423/363/283/223 7-11
7.1 [System Settings] 7
[Leading Edge Adjustment]
Adjust the starting print position at the leading edge of each type of paper (with respect to the paper feed
direction).
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Printer Adjustment] ö [Leading Edge Adjustment].
% To adjust the starting print position at the leading edge of the second side for 2-sided printing (with
respect to the paper feed direction), press [Leading Edge Adjustment (Duplex Side 2)].
2
Select a paper type to be adjusted.
3
Load the paper into the Bypass Tray.
4
Press the Start key.
A test pattern is printed.
5
Check that the distance from the starting print position of the test
pattern to the edge of the paper (a) is 3/16 inches (4.2 mm).
% Press [+] or [-] to adjust the width.
Press the Start key to print a test pattern.
6
Press [OK].
[Centering]
Adjust the starting print position at the left edge of each paper tray (with respect to the paper feed direction).
0 Only 8-1/2 e 11 v (A4 v) paper can be used to adjust the Bypass Tray.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Printer Adjustment] ö [Centering].
% To adjust the starting print position at the left edge of the second side for 2-sided printing (with re-
spect to the paper feed direction), press [Centering (Duplex 2nd Side)].
2
Select a paper tray to be adjusted.
3
Press the Start key.
A test pattern is printed.
4
Check that the distance from the starting print position of the test
pattern to the left edge of the paper (b) is 1/8±1/32 inches (3.0 ±
0.5 mm).
% Press [+] or [-] to adjust the width.
Press the Start key to print a test pattern.
5
Press [OK].
[Maximum Density Adjust-
ment] [3]
Factory default
a
a:3/16 inch (4.2 mm)
b
b:1/8 inches±1/32 inch
(3.0 mm±0.5 mm)