Konica Minolta BIZHUB 223 - Manual (Page 208)

bizhub 423/363/283/223 10-2
10.1 Using an authentication unit (biometric type) 10
10 Authentication unit (biometric type)
This chapter describes the Authentication Unit (biometric type) AU-102.
1.Authentication Unit (biometric type) AU-102
10.1 Using an authentication unit (biometric type)
The Authentication Unit (biometric type) AU-102 is a "biometrics (biometric authentication) system" that
scans finger vein patterns to perform personal authentication. Using the biometric authentication, you can
log in to this machine where user authentication settings are configured in order to execute a print job.
Place your forefinger straight so that your forefinger cushion slightly touches the hollow and protuberance
part of the scanning section. Secure your middle finger and thumb on the both sides of the authentication
unit to prevent your forefinger to be used for authentication from rotating.
For details on how to place your finger on the authentication unit, refer to page 10-16.
NOTICE
Do not place anything other than your finger on the scanning section during scanning operation. Doing so
may cause a malfunction.
Do not disconnect the USB cable from the authentication unit or computer during a scanning operation. Do-
ing so may cause the system to become unstable.
The status indicator LED and notice sound indicate the status of the authentication unit.
To use the Authentication Unit (biometric type) AU-102, first register the user's finger vein patterns in this
machine. The registered user, who is authenticated with the finger vein pattern, can log in to this machine or
execute a print job. This section explains how to configure the required settings in this machine, register us-
ers, and log in with authentication.
1
Status indicator LEDs Status
Lit in green Ready state or authentication is completed
Flash in green During authentication or scanning operation
Lit in red Authentication failed or scanning failed
Unlit The authentication unit is not recognized
Notice sound Status
One short blip sound Scanning starts
One short blip sound During a retry after authentication failed
Two short blip sound Authentication completed
One short blip and one long beep sound Authentication failed
One long beep sound Scanning canceled