Konica Minolta Bizhub 215 - Manual (Page 59)

bizhub 215 4-16
4.5 Making copies on various types of paper 4
11
Press Back to return to the basic screen.
12
Configure other desired settings.
% For details on the basic functions, refer to page 4-2.
% For details on the Application, refer to page 5-2.
13
Press the Start key.
4.5.2 Making copies on custom size paper
As an example, this section describes procedures for loading paper of custom size of 150 mm e 200 mm into
the Bypass Tray and copying the original on the paper.
Tips
- Measure the size of originals or paper of custom size before loading them. It will be convenient to use
the Original Scale.
1
Load the original.
% For details on how to load the original, refer to page 3-11.
2
Adjust the guide of the Bypass Tray, and load paper.
% Load the paper so that the side to be copied is facing down.
% Up to 100 sheets can be loaded into the Bypass Tray. Do not load the sheets up to the point where
the top of the stack is higher than the + mark.
A screen for paper setup appears.
3
Use +, to select [SIZE], then press ).
4
Use +, to select [SIZE INPUT], then press OK.
5
Use the Keypad to enter [150] as the length (X), then press OK.
% Enter the paper length (X) within the range from 140 mm to 432 mm.
% To correct the entered value, press Clear/Stop.
% Refer to the illustration below to enter the length (X) and
width (Y) of the paper correctly.
1. Length (X)
2. Width (Y)