AEG BE2003021W - Manual (Page 11)

A sound operates after the time ends for 2 minutes. or symbol and time setting
flash in the display. The oven stops.
6. Press any button or open the oven door to stop the sound.
If you press button during setting hours for DURATION
, the appliance goes to setting
of the END function.
When END function is activated the Timer/Residual heat indicator shows relation between
Time of day and END time set.
Setting the MINUTE MINDER
Use to set a countdown (maximum 23:59 minutes) This function has no effect on the
operation of the oven
Set the function when the appliance is off:
1. Press .
and " 00 " flash in the display.
2. Press or to set the seconds.
3. Use the same procedure to set minutes and hours.
When you set hours, minutes replaced seconds on the display and hours replaced mi-
nutes. Symbol comes on the display.
4. MINUTE MINDER starts to operate automatically after 5 seconds.
After 90% of set cooking time an acoustic signal sounds.
5. When set time ends, an acoustic signal sounds for 2 minutes and " 00:00 " and flash
in the display.
You can set the MINUTE MINDER any time, even if the oven is off.
If you set the MINUTE MINDER when DURATION or END is running, the symbol goes on
the display. The Timer/Residual heat symbol shows relation between set and current DU-
RATION (or END) time.
Counter
Use the Counter to monitor how long the oven operates. It is on immediately when the
oven starts to heat.
Reset the Counter: press again and again to see the Counter function. Press and hold
and then the Counter start to count up again.
You can not use Counter when Duration or End is set.
USING THE ACCESSORIES
WARNING!
Refer to "Safety information" chapter.
Using the Accessories 11